00000-25-10225P2
ADONIS
DESKTOP MICROPHONE
AM
AMAM
AM-
--
-508E
508E508E
508E
( WITH COMPRESSOR )
* HIGH-QUALITY COMPRESSOR AMP. BUILT-IN
Capable of sending our constant voice level regardless of voice, whispering, loud, etc.
* PROVIDED WITH HIGH-SENSITIVITY ELECTRET CONDENSER MICROPHONE
The Electret Condenser Microphone ensure the better voice quality
* PROVIDED WITH FM/SSB AUDIO QUALITY SELECTOR SWITCH
* PROVIDED WITH ELECTRONIC SWITCHES
SPECIFICATIONS :
・Microphone : Electret Condenser Microphone
・IC : 1 piece
・Transistor :
16 pieces
・Diode : 6 pieces
・Output Voltage :
0-30mV(RMS)
・Power Consumption : 2mA(RX) 3mA(TX)
・Output lmpedance :
500 - 100k ohms
・Compressor Level :
45dB(HIGH) 10dB(Low)
・Dimensions (mm) :
100(W)x155(D)x310(H)
・Weight :
450g
・Power Source :
UM3 x 2
CONTROLS :
① POWER SWITCH
② ON AlR INDICATOR
(LED TX INDICATOR)
③ PTT SWITCH
④ LCCK SWITCH
⑤ UP/DOWN SWITCHES
⑥ Electret Condenser Mic.
: Push it for power “ON”, then, the “ON AlR” indicator
②start to flash. Push it again for the power “OFF”.
: Set the power switch to “ON” then LED② flashes to
indicate the receiving condition. The LED② lights up
continuously when transmitting.
: Use it for short time QSO. Push it for TX and release for
RX. Also use it for releasing of “LOCK” switch.
: Use it for long time QSO. When pushing, the LED “ON
AlR” indicator lights up continuously. For receiving, push
the PTT Switch③.
: Use these switches for frequency UP and DOWN. For
details, please refer to the manual of transceiver.
: The high-sensitivity electret condenser microphone is
applied for clear and better voice quality.
⑦ MIC. OUTPUT CONNECTOR (8P ADONIS TYPE)
Please use the suitable interconnecting cable separately
available.
The Pin Connection of Microphone Output Connector
(ADONIS type)
①
②
③
④
⑤
⑥
⑦
⑧
Ｅ：ＭＩＣ.ＥＡＲＴＨ
Ｍ：ＭＩＣ
Ｐ：ＰＲＥＳＳ ＴＯ ＴＡＬＫ
Ｇ：ＰＲＥＳＳ ＴＯ ＴＡＬＫ（ＥＡＲＴＨ）
Ｕ：ＵＰ
Ｄ：ＤＯＷＮ
Ｃ：Ｕ／Ｄ ＣＯＭＭＯＮ
Ｂ：ＤＣ ＦＥＥＤＩＮＧ（ＤＩＲＥＣＴ ＣＵＲＲＥＮＴ）
E
M
P
B
G
U
D
1
2
3
4
5
6
7
8
（ＶＩＥＷＥＤ ＦＲＯＭ ＴＥＲＭＩＮＡＬ ＰＩＮ ＳＩＤＥ）
C
To Next Page
Need help?
General
