Adrona Crystal EX HPLC

Questions and Answers

M
Mary HardingAug 8, 2025
How to fix 'Filter' message on Adrona Crystal EX HPLC Water Filtration Systems?
- J
  Justin BensonAug 8, 2025
  The "Filter" message on your Adrona Water Filtration System indicates that the pre-filters need replacement (part no. 10320). After replacing the filters, remember to reset the filter counter.
M
Michael Watkins DVMAug 13, 2025
Why do 'LowPres' and 'Running' messages alternate on Adrona Crystal EX HPLC Water Filtration Systems?
- R
  Robert ReynoldsAug 13, 2025
  If your Adrona Water Filtration System displays "LowPres" and "Running" messages alternately, it could be due to low input water pressure (less than 1 bar). This does not affect system operation. Alternatively, the pre-filter or strainer might be clogged. Replace the pre-filter (part no. 10320) or the strainer (part no. 430034).
H
Heather RogersAug 18, 2025
What to do if Adrona Crystal EX HPLC Water Filtration Systems shows 'LowPres'?
- A
  Alyssa FloresAug 18, 2025
  If your Adrona Water Filtration System shows a “LowPres” message, it could be due to several reasons. First, check the input water pressure; if it's less than 1 bar, this message may appear. Also, ensure the pre-filter is installed (part no. 10320). A clogged pre-filter or strainer can also cause this issue; replace the pre-filter (part no. 10320) or the strainer (part no. 430034). Finally, verify the solenoid valve is in order; if not, install the solenoid valve UV (part no. 430020).
A
alexanderpatriciaAug 23, 2025
What does 'TankS' message mean on Adrona Crystal EX HPLC Water Filtration Systems?
- P
  patriciawilliamsAug 23, 2025
  If your Adrona Water Filtration System displays “TankS”, this could be due to a damaged level switch. Check its operation and replace if necessary. It could also be caused by low RO module productivity, with the system taking more than 4 hours to fill the 30 l PRO tank. If water quality is satisfactory, you can ignore the message. Restart the purification system and ensure water flows out of the OUT pipe. If the message persists, replace the DI module (part no. 10310).
G
Grant CooperAug 28, 2025
What to do if Adrona Water Filtration Systems shows 'TnkFull' when the tank is empty?
- J
  Jeffrey JohnsonAug 28, 2025
  If your Adrona Water Filtration System shows “TnkFull” while the tank is empty, check the tank connection cable. If no tank is connected, ensure the tank plug is in the tank socket.
B
bthomasSep 2, 2025
How to troubleshoot no display on Adrona Water Filtration Systems?
- B
  Brian AlvaradoSep 2, 2025
  To address the issue of no display indication when your Adrona Water Filtration System is switched on, check the fuse and supply voltage.