Cloud Link Quick Installation Guide 3
Details
Refer to the figure on the previous page.
LED
On - Activated and communicating with the server.
Flashing - Activated but unable to find the server.
Off - Not activated yet.
LED
On - Wi-Fi devices are connected to the Cloud Link.
Flashing - WPS mode is active.
Off - No Wi-Fi devices are connected to the Cloud
Link.
LED
On - Z-Wave devices are paired with the Cloud
Link.
Flashing - Z-Wave device added or reset mode is
active.
Off - No Z-Wave devices are paired with the Cloud
Link.
LED
Flashing – Unit is starting up or upgrading
firmware.
Off - Unit is powered off.
Port
Use a RJ-45 Ethernet cable to connect the Cloud
Link to your router.
LEDs
On - Ethernet connection established but the
connection is idle.
Flashing - Data is being transmitted or received via
Ethernet connection.
Off - Ethernet connection is not available.
Button
When pressed and held 15 seconds, the device
settings are set to their default values.
To Next Page
Loading...