1. Log into the ADT Interactive app and tap the menu button
2. Tap on ‘Video’, followed by Settings (top right-hand corner)
3. In settings, tap on ‘Recording rules’ and then ‘+ Add New Rule’
4. Once there, tap on ‘Video Analytics’ and select the camera to be calibrated.
5. After the camera completes Video Analytics setup, tap on ‘Close’.
6. Select the camera to be calibrated and tap on ‘Continue’.
7. Position yourself or a helper in front of the camera and take a photo (tap on ‘Take
Photo’).
8. Verify that the entire body is in the field of view and tap on ‘Next’.
9. After taking the photo, take a few steps backward relative to the field of view and
repeat the previous two steps. Repeat this until 5 photos are captured moving a
few steps further from the camera each time. Verify that the entire body is in the
field of view of each photo.
10.After five photos are captured, tap on ‘Submit’.
11. Once the calibration is complete, tap on ‘Done’. The camera is now ready for a
Video Analytics rule.
15
Calibrating the Wi-Fi Camera During Video Analytics Setup
Calibrate the Wi-Fi camera using the ADT Interactive app or via the web browser. If
using a smart phone or tablet, the calibration can be completed by one person,
otherwise you may need an extra pair of hands to support.
Note: The camera's existing Video Motion Detection (VMD) rules will be removed, but they can
be added back later. Tap Ok to delete the VMD rules and continue with calibration.
6 | Configuring Your Camera’s Video Analytics
6.A Calibrate the Wi-Fi Camera Using ADT Interactive App
To Next Page
Loading...
