16
1. Log into ADT Interactive using a web browser and click on ‘Video’.
2. Click on ‘Recording rules’ and then ‘+ Add New Rule’.
3. Click on ’Video Analytics’ and select the camera to be calibrated.
4. After the camera completes Video Analytics setup, click on ‘Close’.
5. Select the camera to be calibrated and tap on ‘Continue’.
6. Position yourself or a helper in front of the camera and take a photo (tap on
‘Take Photo’).
7. Verify that the entire body is in the field of view and tap on ‘Next’.
8. After taking the photo, take a few steps backward relative to the field of view
and repeat the previous two steps. Repeat this until 5 photos are captured
moving a few steps further from the camera each time. Verify that the entire
body is in the field of view of each photo.
9. After five photos are captured, tap on ‘Submit’.
10. Once the calibration is complete, tap on ‘Done’. The camera is now ready for a
Video Analytics rule.
Note: The camera's existing Video Motion Detection (VMD) rules will be removed, but they can
be added back later. Tap Ok to delete the VMD rules and continue with calibration.
6.B Calibrate the Wi-Fi Camera Using ADT Interactive via the Web
6 | Configuring Your Camera’s Video Analytics
To Next Page
Loading...
