Key Fob Battery Replacement Instructions
https://alpha.adt.com/help/93[11/12/2018 10:01:24 PM]
3. Open the key fob by inserting a small instrument, such as a small flathead screwdriver, between the
two halves and twisting gently to separate them. Some key fobs may have a slot at one end of the
fob where you can insert the screwdriver to pry the device open.
4. Observe how the batteries are installed–paying attention to which side of each coin battery is up, [+]
or [-], so that the new batteries can be installed in the same manner.
5. Insert a small flathead screwdriver under the battery and twist to release the battery.
6. Insert the new batteries. Pay attention to which side of the coin battery, [+] or [-], is facing up.
7. Replace the cover by snapping it in place. Reattach the retaining screw, if applicable.
8. Test the key fob by standing in front of the keypad and depressing the key fob buttons to arm and
disarm the system. Verify that the system was armed and disarmed by the key fob.
9. Remove your system from test mode.
To Next Page
Loading...
Need help?
General
