To Next Page

To Previous Page

ADT Video Doorbell

Quick Installation Guide

ADT PULSE

ENROLLAMENT

DBC835 Wireless Doorbell Camera Installation

14.

Factory Reset Instructions:

A. Press the doorbell button to wake up the device

B. If already enrolled, the device will “ding-dong”

C. If not already enrolled, the device will go into WPS mode and

blink green

D. Press and hold the reset button on the back until you hear a

ring (about 10 seconds), then release to start the reset process

E. If you don’t hear the ring, press the doorbell button again to

ensure it is awake and perform step “D” again

F. The unit may need to be charged via USB is the battery is too

low to perform the factory reset

Questions and Answers:

Need help?

Do you have a question about the ADT Pulse DBC835 and is the answer not in the manual?

ADT Pulse DBC835 Specifications

General