To Next Page

To Previous Page

ADT Video Doorbell

Quick Installation Guide

HARDWARE

INSTALLATION

DBC835 Wireless Doorbell Camera Installation

5. Secure the bracket with screws (No. 1 or No. 2). Please see Figure 4-5.

Note: Install the anchors if necessary.

Figure 4-5 Installing the Screws

6. Attach the doorbell camera to the mounting bracket. Make sure the doorbell

camera is firmly fixed and working properly.

Caution: To avoid damaging the rubber seal of the pogo pins, please

attach the camera to the mounting bracket flush. Mounting bracket

should lay flat against the wall. Over torqueing can warp the bracket and

cause it to lose contact with pins

Figure 4-6 Attaching the Camera to the Bracket

7. Turn on the breaker circuit.

8. Check that the chime is working normally by pushing the doorbell button. If

the AC wires are not connected properly, the LED will blink Red every 5

seconds.

Note: Please check if the chime sounds, if not, the chime type should be

changed in the ADT Pulse portal under Manage Devices.

Questions and Answers:

Need help?

Do you have a question about the ADT Pulse DBC835 and is the answer not in the manual?

ADT Pulse DBC835 Specifications

General