6
DBC835 Wireless Doorbell Camera Installation
2 Basic Setup
This section provides information on how to assemble and
configure the DBC835
Doorbell Camera for enrollment.
Installation
1. Power-Up and Check LED
Turn on the switch on the rear side of the doorbell camera and wait for 20
seconds until the LED turns to flashing red.
Note: The internal battery supports about 40 minutes of operation. If you
don’t see the camera powering up, please charge the doorbell camera via
Micro USB cable with USB charger for 45 min before installation.
Figure 2-1 Power LED
2. Enroll the Camera in ADT Pulse
This process is described in section
3 ADT Pulse
Enrollment.
3. Mounting the Doorbell Camera
Mount the camera in its final permanent location. Please refer to section
4
Hardware Installation
for more details.
To Next Page
Loading...