ADT Safewatch QuickConnect Plus Troubleshooting

Lynx & QuickConnect Troubleshooting
https://alpha.adt.com/help/206[11/13/2018 8:20:40 PM]
BYPASS
For more information about Bypass Protection Zones, please refer to the
Ademco Lynx User Guide
or the Safewatch QuickConnect User Guide.
CA/ALARM CANCELED
The alarm has been canceled after sounding during the exit delay. Clear this
message by entering [security code] + [OFF], [security code] + [OFF]. This is an
informational message.
CC/MODEM COMM
The panel is communicating with the Central Station computer and will not
operate while on the line. The message will clear in 1-2 minutes. This is an
informational message.
CHIME
This code appears when the CHIME feature is activated. This is an
informational message.To turn Chime on/off, press [FUNCTION] + [CHIME].
d1 (DL)
The system is either powering up after a recent power outage or is in Standby
Mode. This informational message should clear in 2-3 minutes.
EA/EXIT ERROR
An Exit Alarm has occurred. This alarm is caused by a zone being open at the
end of the exit delay time. It can also be caused when a fault occurs in any
zone within two minutes after an exit delay. Reset the keypad by pressing
[security code] + [OFF], [security code] + [OFF].
FAULT [zone #]
A problem exists with the displayed zone. There will be rapid beeping from
the keypad. Press any key on the keypad to silence the beeping. Refer to the
Peripheral Device Troubleshooting
page. Once the problem has been
corrected, the FAULT display will disappear from the keypad screen.
FAULT 103/LNG RNG
TRBL
This message indicates that there is a problem with the cell unit, a case
tamper or a loss of network registration. Refer to the Communication Failure
Troubleshooting page.
FC/COMM FAIL
The system has failed to communicate with the Customer Monitoring Centers.
Refer to the Communication Failure Troubleshooting
page.
FIRE
A fire alarm or fire zone fault is present. The zone that is experiencing the
fault will display.
For a fire alarm, the keypad and siren will sound:
3 pulses – pause – 3 pulses – pause – 3 pulses - pause…
Reset the keypad by pressing [security code] + [OFF], [security code] + [OFF].
If the keypad does not clear, the smoke detector may still be detecting smoke
or heat. Remove the source of the smoke or heat if it can be done safely. It
may be necessary to fan the detector for 30 seconds to clear the smoke from

ADT Safewatch QuickConnect Plus Specifications

General

Brand	ADT
Model	Safewatch QuickConnect Plus
Category	Security System
Language	English