ADT Safewatch QuickConnect Plus - Page 26

– 26 –
USER FUNCTIONS
Remote Phone Control Feature
Enter: (within eight seconds)
Your user code
Upon entering remote phone control mode the ADT Safewatch

QuickConnect Plus
Security System
will announce “System, enter code”.
Remote Phone Control Commands
To remotely disarm system:
+ [1]
Your user code
To remotely arm in AWAY mode: + [2]
Your user code
To remotely arm in STAY mode: + [3]
Your user code
To remotely Bypass zones: + [6] + zone no.
Your user code
To remotely activate Forced Bypass: + [6] + [#]
Your user code
To remotely check system status: [✻]
To end remote phone session:
Hang Up or + [9]
Your user code
NOTES: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been
bypassed.