64
• Step 2 (50 % operation): ‘ON button’ flashes quickly.
• Step 1 (10 % operation): ‘ON button’ flashes slowly.
When you want to switch of the pellet burner, push the ON/OFF button or use the app.
The pellet function can burn up to 24 hours on a full pellet container at level 1, 12 hours at level 2, and 8
hours at level 3. The stove is capable of running day and night, if pellets are added in time.
3.3.5 Lighting the fire with wood and pellets at the same time
Cold stove
Put dry wood in the combustion chamber - just as if you wanted to start the stove manually (see section
3.3.1). However, you won’t need any firelighters. The fire is lid with pellets. It will be an advantage, if you
start with a closed air inlet until the fire is burning in the pellet burner. After this, you can open the air inlet for
easier lighting of the firewood. When the logs have caught fire and the smoke temperature is about 280
degrees, the pellet supply will stop automatically.
The stove in pellet operation
When the stove is in pellet operation, you can always add firewood – you just have to remember to close the
door within 3 minutes. Open the door carefully and the pellet supply will stop and the ALARM flashes red.
Add firewood of the correct quality and respect the MAX load line. Close the door again. The stove will now
continue combustion of pellets. When the logs are burning and the smoke temperature is about 280 degrees,
the pellet supply stops automatically. After this, the stove will change to WOOD BURNING mode.
If you use the function "Heat Level" on the app and want the stove to restart automatically
on pellets when the wood has burned out, you can set the Aduro Hybrid on standby mode
with just 1 click on the button (see illustration). The stove will now be in standby mode and
await a smoke temperature below 100 degrees before it starts the pellet combustion and
ignites again. However, if you use the function "Desired Room Temperature", the Hybrid will
start automatically again when the smoke temperature is below 100 degrees.
IMPORTANT!
If the door to the combustion chamber is open for more than 3 minutes, the pellet combustion will shut
down and must be started again by pushing ON/OFF. The stove starts when the smoke temperature is
below 100 degrees. If the stove flashes green ON, it means that the stove will start, but is waiting for the
smoke temperature to be below 100 degrees C or timer.
When you want to switch off the pellet burner, push the ON/OFF button. If you open the stove door during
operation, the red ALARM will light. If you close the door before 3 minutes, the pellet burner goes back to
ON mode automatically.
3.4 How should I use my Aduro H5?
The Aduro H5 is intended for intermittent combustion. This means that each stoking should burn down to
embers before new logs are added.
In order to obtain the best possible combustion, you should regulate the effect/heat output with the fuel.
Burning small logs provides more powerful combustion than burning large logs as the surface area is greater
To Next Page
Loading...
