Need help?Do you have a question about the Advance acoustic X-A160 and is the answer not in the manual?
General| Total Harmonic Distortion (THD) | <0.03% (1kHz, 1W) |
|---|---|
| Signal-to-Noise Ratio | > 100 dB |
| Outputs | Speaker terminals |
| Damping Factor | > 100 |
| Power Output | 80W RMS per channel into 8 Ohms |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 47 kOhm |
| Inputs | RCA |
| Dimensions (W x H x D) | 430 x 360 mm |
Warnings against electric shock and opening the unit; refer servicing to qualified personnel.
Avoid exposing the appliance to moisture and handle with care during transportation.
Read, retain, heed, and follow all safety and operating instructions for proper use.
Ensure proper placement, ventilation, and avoid water/heat exposure.
Proper power connection, grounding, cord protection, and preventing object entry.
Guidelines for cleaning, non-use periods, and when to seek qualified service.
Controls power ON/OFF and standby mode for the amplifier.
Indicate peak power level and average power on channels into an 8 ohm load.
Selects Class'A bias mode, affecting temperature and ventilation needs.
Master power switch and automatic voltage selection (115V/230V).
Connect speakers using correct polarity (+/-) for left and right channels.
Connect to balanced preamplifier outputs for optimal signal integrity.
Connect to unbalanced preamplifier outputs for audio signal input.
Control ON/OFF of other power amplifiers via trigger signal.
Option to switch off the VU meter illumination for preference.
To Next Page