Need help?Do you have a question about the Advanced Energy LumaSense Technologies E2T QUASAR Series and is the answer not in the manual?
General| Accuracy | ±1°C or ±1% of reading |
|---|---|
| Response Time | 10 ms |
| Operating Temperature | -20 to 60°C |
| Housing | Stainless Steel |
| Housing Material | Stainless Steel |
| Protection Class | IP65 |
| Output | 4-20 mA |
| Power Supply | 24 VDC |
| Output Signal | 4-20 mA, 0-10 V |
| Interface | RS-485 |
| Emissivity Setting | 0.10 to 1.00 in 0.01 increments |
Discusses important safety information for installing and operating the LumaSense instrument.
Details procedures for contacting support, requesting service, and returning instruments for repair.
Explains how the QUASAR M8100-EXP collects and processes infrared energy for monitoring.
Provides a checklist for a quick installation of the instrument.
Covers considerations for aligning the instrument for optimal viewing and avoiding solar interference.
Provides instructions for focusing the instrument's optics on the target.
Provides general guidelines for the electrical installation of the instrument.
Details how to connect the input power to the instrument.
Step-by-step guide for the initial start-up and configuration of the Pilot Monitor.
Step-by-step guide for the initial start-up and configuration of the Flare Monitor.
Procedures to check and mitigate noise amplification for the Flare Monitor.
Step-by-step guide for the initial start-up and configuration of the Smoke Monitor.
Details setting initial controls for the Smoke Monitor.
Guides on optimizing system gain and climate compensation for the Smoke Monitor.
Outlines steps to diagnose and isolate problems with the instrument.
Covers general maintenance procedures and safety precautions for the instrument.
Details safety measures for operating the instrument in hazardous environments.
Covers over-voltage and other electrical protection measures for the instrument.
Presents the CSA International Certificate of Compliance for the product.
To Next Page