1-3 Common technical specification of ADAM-6000
• Ethernet: 10 BASE-T IEEE 802.3
100 BASE-TX IEEE 802.3u
• Wiring: UTP, category 5 or greater
• Bus Connection: RJ45 modular jack
• Comm. Protocol: Modbus/TCP on TCP/IP and UDP
• Data Transfer Rate: Up to 100 Mbps
• Unregulated 10 to 30VDC
• Protection: Over-voltage and power reversal
• Ethernet Communication: 1500 V DC
• I/O Module: 3000 V DC
• Status Indicator:
Power, CPU, Communication (Link, Collide, 10/100 Mbps, Tx, Rx)
• Case: ABS with captive mounting hardware
• Plug-in Screw Terminal Block:
Accepts 0.5 mm
2
to 2.5 mm
2
, 1 - #12 or 2 - #14 to #22 AWG
• Operating Temperature: - 10 to 70º C (14 to 158º F)
• Storage Temperature: - 25 to 85º C (-13 to 185º F)
• Humidity: 5 to 95%, non-condensing
• Atmosphere: No corrosive gases
NOTE: Equipment will operate below 30% humidity. However, static electricity problems occur much
more frequently at lower humidity levels. Make sure you take adequate precautions when you
touch the equipment. Consider using ground straps, anti-static floor coverings, etc. if you use the
equipment in low humidity environments.
To Next Page
Loading...
Need help?
General
