5-3-3 Add Remote Stations
To meet the remote monitoring and maintenance requirements, The ADAM-6000 and ADAM-5000/TCP
System does not only available to operate in local LAN, but also allowed to access from Internet or
Intranet. Thus users would able to configure an ADAM-6000 and ADAM-5000/TCP easily no matter how
far it is.
Select item Tool\Add Remote Ethernet I/O in function menu or click the button, the adding station
screen will pop up as Figure 5-8. Then key-in the specific IP address and click the Add button. If the
communication success, the added ADAM Ethernet I/O unit should appeal on the tree-structure display
area.
Figure 5-8 Adding ADAM Ethernet I/O Screen
Note There are several conditions need to be sure before adding a remote ADAM-6000 or
ADAM-5000/TCP system in the windows Utility.
1. Be sure the specific IP is existed and available.
2. Be sure to complete the network linkage for both sides.
3. Be sure to adjust the best timing of timeout setting.
4. Even you are not sure whether the communication is workable or not, there is also a “PING”
function for testing the network connection.
To Next Page
Loading...
