1-2 Major Features
1-2-1 Ethernet-enabled DA&C I/O Modules
ADAM-6000 is based on the popular Ethernet networking standards used today in most business
environments. Users can easily add ADAM-6000 I/O modules to existing Ethernet networks or use
ADAM-6000 modules in new Ethernet-enabled eManufacturing networks. ADAM-6000 module features
a 10/100 Mbps Ethernet chip and supports industrial popular Modus/TCP protocol over TCP/IP for data
connection. ADAM-6000 also supports UDP protocol over Ethernet networking. With UDP/IP,
ADAM-6000 I/O modules can actively send I/O data stream to 8 Ethernet nodes. Through Ethernet
networking HMI/SCADA system and controller can access or gather real-time data from ADAM-6000
Ethernet enabled DA&C modules. And, these real-time data can be integrated with business system to
create valuable, competitive business information immediately.
1-2-2 Intelligent I/O Modules
Enhancing from traditional I/O modules, ADAM-6000 I/O modules have pre-built intelligent mathematic
functions to empower the system capacity. The Digital Input modules provide Counter, Totalizer
functions; the Digital Output modules provide pulse output, delay output functions; the Analog Input
modules provide the Max./Min./Average data calculation; the Analog Output modules provide the PID
loop control function.
1-2-3 Mixed I/O in One Module to fit all application’s
ADAM-6000 mixed I/O module design concept provides the most cost-effective I/O usage for application
system. The most common used I/O type for single function unit are collected in ONE module. This
design concept not only save I/O usage and spare modules cost but also speed up I/O relative
operations. For small DA&C system or standalone control unit in a middle or large scale, ADAM-6000
mixed I/O design can easily fit application needs by one or two modules only. With additional embedded
control modules, ADAM-6000 can easily create a localized, less complex, and more distributed I/O
architecture.
1-2-4 Embedded web built web page for remote monitoring and diagnose
Each ADAM-6000 module features a pre-built I/O module web page to display real-time I/O data value,
alarm and module status thru LAN or Internet. Just Internet browser, users can easily monitor real-time
I/O data value and alarm no matter local site or remote site. Then, the web-enabled monitoring system
is completed immediately without any programming effort.
To Next Page
Loading...
Need help?
General
