Advantech WISE-710 - Page 3

WISE-710 Startup Manual 3
9. Install the PCBA as shown below
10. AfxthePCBAinplaceusing2screws
11. Replace the 2 COM port nuts
12. Fasten the GND screw
13. InserttheWi-Fimoduleandafxitinplaceusing1
screw
14. Plug the SMA cable into the wireless module
15. Replace the rear cover
16. Afxtheantennatotheantennasocket
1. Removetherearcoverbyusingaatheadscrewdriver
to push and release the 2 side clips
2. Connect the expansion module to the main board
3. Replace the rear cover
Wi-Fi Module and Antenna Installation
Expansion Module Installation