Battery Installation
How To Fill In Water For Smoking Effect
Contents
RC T-Rex x 1
RC Transmitter x 1
15
(49 feet)
Fig. 3
Transmitter
Fig. 4
3 x AA
For T-Rex
(Included)
2 x AA
For Transmitter
(Not Included)
T-Rex
87412
573756056
NO.:
Light, Sound
& Smoking
Effect
Move Forward
2.4 GHz
Signal light
Transmitter - Battery Installation
Fig. 2
- RC T-Rex x 1
- RC Transmitter (Transmitter) x1
- Water Rump x 1
1. Alkaline batteries are recommend to be used
2. Only batteries of the same or equivalent type as recommended are to be used
3. Do not mix alkaline, standard or rechargeable batteries
4. Do not mix old and new batteries or different type of batteries
5. Non-rechargeable batteries are not to be charged
6. If rechargeable batteries are to be used, they are only to be charged under adult supervision
7. Rechargeable batteries are to be removed from the product before they are charged
8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
9. Remove all batteries from the Vehicle and Transmitter when not in use
10. Exhausted batteries are to be removed from the product
11. The supply terminals are not to be short-circuited
12. Dispose of batteries properly / Do not dispose the batteries in fire - it may cause them to explode or leak causing injury or damage
13. Battery installation and removal must only be done by an adult
For T-Rex (Fig. 1 and Fig. 2)
1. Switch OFF the power
2. Unscrew the screw on the battery cover
3. Open the battery cover
4. Install 3 new 1.5V”AA” batteries with correct polarities (+/-)
5. Close the battery cover
6. Tighten the screw on the battery cover
For Transmitter (Fig. 3 and Fig. 4)
1. Unscrew the screw on the battery cover
2. Open the battery cover
3. Install 2 new 1.5V “AA” batteries with correct polarities (+/-)
as shown inside the battery compartment
4. Close the battery cover
5. Tighten the screw on the battery cover
age
6
PRO. SYSTEM
Fig. 1
Fig. 5 Fig. 6
Fig. 7 Fig. 8
T-Rex
1. Fill in clear water into the water purmp.
2. Open the cap of water tank on the T-Rex (Fig.5 and Fig.6)
3. Fill in clear water to T-Rex by using the provided
water pump. (Fig.7)
4. Close the cap firmly. (Fig.8)
To Next Page
Need help?
General