A-44 V2/A-54 V2
·
Quick Start Guide
12
Note:
Press RESET for approximately 10 seconds when the camera is
powering on or rebooting to restore the default settings, including
the user name, password, IP address, port No., etc.
2 Installation
Before you start:
Make sure the device is in good condition and all the assembly
parts are included.
Make sure all the related equipment is powered-off during the
installation.
Check the specifications of the products to ensure they match the
installation environment.
Make sure the power supply matches the required voltage to
avoid damage.
If the product does not function properly, please contact your
dealer or the nearest service center. Do not disassemble the
camera for repair or maintenance by yourself.
Make sure that the wall is strong enough to withstand three times
the weight of the camera.
Note:
Please pay attention to the following precautions to prevent IR
reflection:
To Next Page
Loading...
