Aeca PR 0606 Night - Safety Notes and Exemption from Liability; General Safety Notes

1 Safety Notes and Exemption from Liability
Safety notes for personal protection are marked with this symbol.
!
Notes concerning the functional safety of the system are printed in bold type.
The safety notes supplied by manufacturers for additional components that you may connect to this controller must be
observed and are not suspended by these instructions. Please consult a specialist dealer in the event of contradictions
between different instructions.
1.1 General Safety Notes
It is imperative that you observe the following for your safety during installation: avoid creating sparks during all
work! Solar modules generate electricity on the incidence of light. The full voltage is present even when the
incidence of light is low. Therefore please work carefully and take the appropriate safety precautions. Provide the
solar modules with an opaque cover securely fixed with adhesive tape. It is possible to de-energise the modules completely
by using this cover.
!
Double the values of the system voltages may occur during assembly and electrical installation in the direct current circuit of
the photovoltaic system (up to 24V in the 12V system, up to 48V in the 24V system).
Therefore never touch bare cable ends!
Immediately insulate every bare cable end that is not going to be connected straight away.
Only carry out work on a dry surface! Components (solar modules, cables, etc.) may not be wet or damp during
assembly!
Use only well-insulated tools!
Any obstruction to the device’s ventilation may lead to overheating and failure of the device. Do not cover ventilation
apertures and cooling elements.
The controller may not be installed and operated in wet rooms (e.g. bathrooms) or in rooms where highly flammable
gas mixtures may arise due to gas cylinders, paints, varnishes, solvents, etc!
Do not store any of the substances mentioned in rooms where the solar controller has been installed!
The factory-fitted plates and identification symbols may not be modified, removed or disfigured.
SLX Night Operating Instructions page 3