AEG Electrolux LAVATHERM 88800

Questions and Answers

V
Vanessa FosterAug 17, 2025
Why AEG Electrolux LAVATHERM 88800 Dryer does not work?
- S
  Sandra GarnerAug 17, 2025
  Your AEG Electrolux Dryer might not be working due to several reasons: * The mains plug may not be properly plugged in, or the fuse might be faulty. Ensure the dryer is plugged into the mains socket and check the fuse in the fuse box. * The loading door could be open. Make sure to close the loading door properly. * The START PAUSE button may not have been pressed. Press the START PAUSE button again to start the dryer.
L
Lori RogersAug 20, 2025
What to do if AEG Electrolux LAVATHERM 88800 Dryer programme inactive and displays: The tank is full. Please empty it and then press START or Please empty the tank.?
- S
  Stephanie JohnsonAug 20, 2025
  If your AEG Electrolux Dryer displays a message indicating that the condensate tank is full, it means that the condensate tank needs to be emptied. Empty the condensate tank, then start the programme by pressing the START PAUSE button.
S
srussellAug 23, 2025
What to do if drying results are unsatisfactory with my AEG Electrolux LAVATHERM 88800?
- S
  Selena MiddletonAug 23, 2025
  If you're experiencing unsatisfactory drying results with your AEG Electrolux Dryer, consider the following: * Ensure you've selected the correct programme for your load. * Clean the lint and fluff filters, as clogged filters can impede drying performance. * Also, clean the heat exchanger if it's clogged with lint. * Avoid overloading the machine and ensure ventilation slots are not covered. * Clean any residue on the inside surface of the drum or drum ribs. You may also need to adjust the dryness function or re-programme the standard setting for the degree of drying.
L
Leslie CoffeyAug 26, 2025
Why AEG Electrolux LAVATHERM 88800 drying cycle lasts an unusually long time?
- A
  Andre PetersonAug 26, 2025
  An unusually long drying cycle in your AEG Electrolux Dryer can be due to: * Clogged lint and/or fluff filters. Clean them to ensure proper airflow. * An overloaded drum. Reduce the load volume. * Laundry that wasn't spun sufficiently. Ensure laundry is adequately spun before drying. * High room temperature, which may cause the compressor to temporarily switch off. If possible, lower the room temperature. Note that the drying cycle ends automatically after approximately 5 hours.
A
Andrew BlakeAug 28, 2025
Why AEG Electrolux LAVATHERM 88800 Dryer drying cycle ends shortly after programme starts?
- G
  Gary McbrideAug 28, 2025
  If the drying cycle of your AEG Electrolux Dryer ends shortly after the programme starts, it could be because not enough washing was loaded, or the washing is too dry for the selected programme. To resolve this, select a time programme or a higher drying level, such as INTENSIVE DRY instead of STORAGE DRY.
T
tracybestAug 31, 2025
Why AEG Electrolux Dryer buttons are not reacting?
- D
  Danielle SchmittAug 31, 2025
  If your AEG Electrolux Dryer isn't responding when you press a button, it might be due to the drying protection feature. Since this option can no longer be set after the programme has started, turn the programme knob to OFF (UIT) and then set the programme again.
M
monica22Sep 2, 2025
Why AEG Electrolux LAVATHERM 88800 garments are not sufficiently smooth after Pro Steam programme?
- A
  Ashley JohnsonSep 2, 2025
  If garments aren't smooth enough after using the Pro Steam programme on your AEG Electrolux Dryer, consider these factors: * Ensure you've selected the correct programme for the fabric type (e.g., COTTON instead of SYNTHETICS). * Increase the steam level setting. * Reduce the number of garments in the machine, or only load similar items. * Remove clothes promptly after the anti-crease phase, hang them on clothes hangers, do up buttons, and tug them into shape. For multi-layered garments, reshape them by ironing after they come out of the machine.
R
Robert HumphreySep 5, 2025
Why AEG Electrolux LAVATHERM 88800 Dryer programme time changes erratically?
- D
  Dalton CampbellSep 6, 2025
  If the displayed programme time on your AEG Electrolux Dryer changes erratically or remains unchanged for a long period, it's because the programme time is automatically adjusted based on the type and volume of laundry, as well as the level of dampness. This is a normal automatic process and not a machine fault.
T
Tommy ChenSep 8, 2025
Why AEG Electrolux LAVATHERM 88800 Dryer garments have no creases after Pro Steam programme?
- L
  Luis BrockSep 8, 2025
  The Pro Steam programme on your AEG Electrolux Dryer is designed to smooth garments. If you need creases, iron them in after the Pro Steam programme.
C
Cole SnowSep 12, 2025
Why AEG Electrolux LAVATHERM 88800 Dryer drum light does not work?
- K
  Kimberly OlsenSep 12, 2025
  If the drum light in your AEG Electrolux Dryer isn't working, ensure that the programme selector is not in the OFF (UIT) position. Turn the programme selector to the LIGHT setting or to any programme. If that doesn't work, the light bulb may be defective and need replacement.