Operating Instructions
22
Starting the Washing Program
0 1. Check whether the water tap is open.
2. Start the washing program: press the START/PAUSE
button.
The washing program is started, or starts at the end of
the time delay set.
3
If the DOOR indicator flashes red when the START/PAUSE button is
pressed, the door is not properly closed. Close the door firmly and press
the START/PAUSE button again.
If the delay timer has been set:
The start time delay set on the delay timer counts down; the time
remaining until the program starts is displayed on the multi-display (in
whole hours remaining). During this time you can add washing, change
or stop the delay timer.
• Adding washing: press the START/PAUSE button, the door can be
opened. Then close the door and press the START/PAUSE) button
again.
• Changing or stopping delay timer: press the DELAY TIMER button
repeatedly until the desired time is displayed; when the program
duration is displayed (display in minutes, e.g.119), the washing pro-
gram starts without delay.
To Next Page
Loading...
