7www.aeg.com
10
steam station iron on the iron rest.
11 switch o by pressing the ON/OFF button. Put the iron on the iron rest area and switch
the locking mechanism to
in order to secure the iron.
12
steam station base.
CLEANING
13 Unscrew the boiler cap. Turn the appliance side over
a sink and completely empty the boiler.
14 Mix a descaler agent and water at the specied ratio, prepare at least 300ml descaler mixture. (Use the recommended ratio
for the mixture. If there is much scaling, properly increase the proportion of descaler.)
Note: We recommend to use the descaler ECF5 from AEG. Please follow the water/ descaler liquid ratio instructions on
the bottle. We recommend to clean the product every 2 months.
15 Pour out the mixture. Fill the boiler with clean water, then pour it out. Repeat this step for several times until the scale is re-
moved and there is no longer a descaler smell. Place back one measuring cup of clean water in the boiler before reassembling.
THE WARRANTY DOES NOT COVER DAMAGE CAUSED BY CLOGGING DUE TO LIME. Once cleaning is done, do not keep
the boiler completely empty but leave some water still there (before closing it again).
16 Insert the cleaning brush into the boiler opening and clean-out water remnants and lime residues while holding the appli-
ance over a sink.
17 Clean the appliance with a slightly damp cloth. To remove stubborn stains, you may apply a small amount of non-abrasive
cleaner.
SAFETY ADVICE
Read the following instruction carefully before using machine for the rst time.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Keep the iron and its cord out of reach of children less than 8 years of age when it is
energized or cooling down.
• The surfaces are liable to get hot during use
.
• This product is appropriate for use with tap water. It is recommended to use AEG
AquaSense ltered water, taking out impurities like limescale. Otherwise use distilled
water. If the tap water is particularly hard, use a mix of 50% distilled water and 50%
tap water.
• The appliance may only be connected to a power supply whose voltage and
frequency comply with the specications on the rating plate!
• The iron is not to be used if it has been dropped, if there are visible signs of damage
on the iron or its cord or if it is leaking.
• The appliance must only be connected to an earthed socket. If necessary an extension
cable suitable for 10 A can be used.
• If the appliance or the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied person, in order to avoid hazard.
GB
To Next Page
Loading...
Need help?
General
