8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to the
"Installation" chapter.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
9. NOISES
SSSRRR!
CLICK!
HISSS!
BRRR!
BLUBB!
10. TECHNICAL DATA
The technical information is situated in the
rating plate on the internal side of the
appliance and on the energy label.
Voltage 230-240 V
Frequency 50 Hz
11. INFORMATION FOR TEST INSTITUTES
Installation and preparation of the appliance
for any EcoDesign verification shall be
compliant with EN 62552 (EU). Ventilation
requirements, recess dimensions and
minimum rear clearances shall be as stated
in this User Manual in "Installation". Please
contact the manufacturer for any other further
information, including loading plans.
ENGLISH 83
To Next Page
Loading...
