Problem Possible cause Solution
The circuit breaker tripped
or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to the "Operation" chap‐
ter.
The room temperature is
too high.
Refer to the "Installation"
chapter.
The door is opened too of‐
ten.
Do not keep the door open
longer than necessary.
The door is not closed cor‐
rectly.
Refer to the "Closing the door"
section.
The light does not work. The light is turned off. Turn on the light. Refer to the
"Light setup" section.
The appliance is not plug‐
ged in.
Connect the appliance.
The circuit breaker tripped
or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The lamp is defective. Contact the Authorised Serv‐
ice Centre.
The light button is not op‐
erating.
Contact the Authorised Serv‐
ice Centre.
Too much vibration. The appliance is not sup‐
ported properly.
Check if the appliance stands
stable.
The appliance is noisy. The appliance is not sup‐
ported properly.
Check if the appliance stands
stable.
Water flows on the rear plate
of the appliance.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the wine
cabinet.
The appliance drain is
clogged.
Clean the appliance drain
hole. Refer to the "Cleaning
the drain" section.
Water flows inside the wine
cabinet.
Products prevent that wa‐
ter flows into the water col‐
lector.
Make sure that products do
not touch the rear plate.
The temperature in the wine
cabinet is too low or too
high.
The temperature regulator
is not set correctly.
Set a higher or lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to the "Closing the door"
section.
ENGLISH 15
To Next Page
Loading...
