AEG AWUS052B5B - Troubleshooting

9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem Possible cause Solution
The appliance does not op‐
erate.
The appliance is switched
off.
Switch on the appliance.
The mains plug is not con‐
nected to the mains socket
correctly.
Connect the mains plug to the
mains socket correctly.
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The circuit breaker tripped
or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to "Operation" chapter.
The room temperature is
too high.
Refer to "Installation" chapter.
The door is opened too of‐
ten.
Do not keep the door open
longer than necessary.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The light does not work. The appliance is not plug‐
ged in.
Connect the appliance.
The circuit breaker tripped
or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The lamp is defective. Contact the service.
The light button is not op‐
erating.
Contact the service.
Too much vibration. The appliance is not sup‐
ported properly.
Check if the appliance stands
stable.
The appliance is noisy. The appliance is not sup‐
ported properly.
Check if the appliance stands
stable.
Water flows on the rear plate
of the appliance.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
www.aeg.com14