12.4 Removing and installing door
The oven door has two glass panels. You can
remove the oven door and the internal glass
panel to clean it. Read the whole "Removing
and installing door" instruction before you
remove the glass panels.
CAUTION!
Do not use the appliance without the
glass panels.
1. Open the door fully and hold both hinges.
2. Lift and pull the latches until they click.
3. Close the oven door halfway to the first
opening position. Then lift and pull to
remove the door from its seat.
4. Put the door on a soft cloth on a stable
surface and release the locking system to
remove the internal glass panel.
5. Turn the fasteners by 90° and remove
them from their seats.
6. First lift carefully and then remove the
glass panel.
7. Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the
dishwasher.
8. After cleaning, install the glass panel and
the oven door.
If the door is installed correctly, you will hear
a click when closing the latches.
When installed correctly, the door trim clicks.
Make sure that you install the internal glass
panel in the seats correctly.
12.5 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
ENGLISH 15
To Next Page
Loading...
