Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table please
contact an Authorised Service Centre.
Problem Cause and remedy
The appliance does not
heat up.
The fuse is blown. Make
sure that the fuse is the
cause of the malfunction.
If the problem persists,
contact a qualified electri‐
cian.
The door gasket is dam‐
aged.
Do not use the appliance.
Contact an Authorised
Service Centre.
The display shows
"12.00".
There was a power cut.
Set the time of day.
Problem Cause and remedy
The lamp does not work. The lamp is burnt out.
Replace the lamp. Refer
to "Care and cleaning",
Replacing the lamp.
13.2 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is located
on the front frame of the appliance. It is
visible when you open the door. Do not
remove the rating plate from the appliance.
We recommend that you write the data
here:
Model (MOD.) :
Product number (PNC):
Serial number (S.N.):
14. ENERGY EFFICIENCY
14.1 Product Information Sheet and Product Information according to EU
and UK Energy Labelling and Ecodesign Regulations
Supplier's name AEG
Model identification BCX23101EM 944068450
Energy Efficiency Index 95.1
Energy efficiency class A
Energy consumption with a standard load, conventional mode 0.89 kWh/cycle
Energy consumption with a standard load, fan-forced mode 0.78 kWh/cycle
Number of cavities 1
16 ENGLISH
To Next Page
Loading...
