Before the pyrolytic cleaning:
Turn off the oven and
wait until it is cold.
Remove all accessories. Clean the oven floor and the in-
ner door glass with warm water,
a soft cloth and a mild deter-
gent.
Step 1
Set the function: . - flashes.
Step 2 Turn the control knob (for the temperature) to set the cleaning mode.
Option Cleaning mode Duration
P1 Light cleaning 1 h 30 min
P2 Normal cleaning 2 h 30 min
Step 3
- press to start the cleaning.
Step 4 After cleaning, turn the knob for the heating functions to the off position.
During the cleaning the oven lamp is off. The oven door stays locked. When the oven
is cold, the door unlocks.
When the oven is at the set temperature, the door locks. Until the door unlocks the dis-
play shows: the bars of the heat indicator, . To stop cleaning before it is completed,
turn the knob for the oven functions to the off position.
When the cleaning ends:
Turn off the oven and
wait until it is cold.
Clean the cavity with a soft
cloth.
Remove the residue from the
bottom of the cavity.
12.4 Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the oven.
The cleaning reminder
goes out:
• after the end of the
pyrolysis.
• if you press and
at the same time
while PYR flashes in the
display.
12.5 How to clean: water tank
Do not pour water into the water tank
during the cleaning.
ENGLISH 37
To Next Page
Loading...
