Problem Possible cause Remedy
The display shows an error
code that is not in this table.
There is an electrical fault. • Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
The descaling procedure is
interrupted before it finishes.
There was a power cut. Repeat the procedure.
The descaling procedure is
interrupted before it finishes.
The function was stopped by
the user.
Repeat the procedure.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
You did not fill the water
drawer to the maximum lev-
el.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The grill- / roasting pan is on
a wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
The cleaning function is in-
terrupted before it finishes.
There was a power cut. Repeat the procedure.
The cleaning function is in-
terrupted before it finishes.
The function was stopped by
the user.
Repeat the procedure.
There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.
You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.
Cover all parts of the cavity
with a thin layer of the deter-
gent. Spray the detergent
evenly.
There is no good perform-
ance of the cleaning proce-
dure.
The initial oven cavity tem-
perature of the steam clean-
ing function was too high.
Repeat the cycle. Run the cy-
cle when the appliance is
cold.
There is no good perform-
ance of the cleaning proce-
dure.
You did not remove the side
grids before the start of the
cleaning procedure. They
can transfer heat to the walls
and decrease the perform-
ance.
Remove the side grids from
the appliance and repeat the
function.
ENGLISH 51