Before you replace the lamp:
Step 1 Step 2 Step 3
Turn off the oven. Wait until
the oven is cold.
Disconnect the oven from the
mains.
Put a cloth on the bottom of
the cavity.
Top lamp
Step 1 Turn the glass cover to remove it.
Step 2 Remove the metal ring and clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Attach the metal ring to the glass cover and install it.
Side lamp
Step 1 Remove the left shelf support to get access to the lamp.
Step 2 Use a Torx 20 screwdriver to remove the cover.
Step 3 Remove and clean the metal frame and the seal.
Step 4 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 5 Install the metal frame and the seal. Tighten the screws.
Step 6 Install the left shelf support.
46/64
CARE AND CLEANING
To Next Page
Loading...
