AEG CIB6732ACM User Manual

5.3 Setting and changing the
time
You must set the time before you
operate the oven.
When you connect the appliance to the
electrical supply or after a power cut,
flashes.
Press the or to set the correct
time.
After approximately 5 seconds, the
flashing stops and the display shows the
time of day.
To change the time, press again and
again until starts to flash.
5.4 Preheating
Preheat the empty oven before first use.
Preheat the two ovens
before first use. Heat up one
oven at a time.
Set the functions listed
below, if applicable.
1. Set the function . Set the
temperature to 250ºC.
2. Let the oven operate for 1 hour.
3. Set the function
. Set the
temperature to 250ºC.
4. Let the oven operate for 15 minutes.
5. Turn off the oven and let it cool
down.
Accessories can become hotter than
usual. The oven can emit an odour and
smoke. Make sure that the airflow in the
room is sufficient.
6. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Hob control panel
321
4
8
9
5
7
6
Use the sensor fields to operate the appliance. The displays, indicators and sounds tell
which functions operate.
Sensor
field
Function Comment
1
- Heat setting display To show the heat setting.
2
- Timer indicators of cook-
ing zones
To show for which zone you set the time.
ENGLISH 11

AEG CIB6732ACM Specifications

General

Brand	AEG
Model	CIB6732ACM
Category	Cookers
Language	English