Problem Possible cause Remedy
Automatic Heat Up function
does not operate.
The highest heat setting is
set.
The highest heat setting has
the same power as the func‐
tion.
The sensor fields become
hot.
The cookware is too large or
you put it too near to the
controls.
Put large cookware on the
rear zones if possible.
There is no signal when you
touch the panel sensor
fields.
The signals are deactivated. Activate the signals. Refer to
"Hob - Daily use" chapter.
comes on the hob dis‐
play.
Automatic Switch Off oper‐
ates.
Deactivate the hob and acti‐
vate it again.
comes on the hob dis‐
play.
The Child Safety Device or
the Lock function operates.
Refer to "Hob - Daily use"
chapter.
comes on the hob dis‐
play.
There is no cookware on the
zone.
Put cookware on the zone.
comes on the hob dis‐
play.
The cookware is incorrect. Use the correct cookware.
Refer to "Hob - Hints and
tips" chapter.
comes on the hob dis‐
play.
The diameter of the bottom
of the cookware is too small
for the zone.
Use cookware with correct
dimensions. Refer to "Hob -
Hints and tips" chapter.
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display shows "12.00". There was a power cut. Reset the clock.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
There is no good cooking
performance using the
Steam Bake function.
You did not fill the cavity em‐
bossment with water.
Refer to "Activating the
Steam Bake function".
The water in the cavity em‐
bossment does not boil.
The temperature is too low. Set the temperature at least
to 110°C. Refer to "Hints and
Tips" chapter.
www.aeg.com36
To Next Page
Loading...
Need help?
General
