While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones or
burners, gentle frying.
While boiling, frying big quantities of food without a lid, cooking on
multiple cooking zones or burners.
While boiling, frying big quantities of food without a lid, big humidi‐
ty. The hood operates on maximum speed. After 6 minutes the ap‐
pliance returns to previous setting.
It is recommended to leave the hood
operating for approximately 15 minutes
after cooking.
To operate the hood:
1. Press the first speed button to switch
on the appliance.
2. If needed, press the light button to
illuminate the cooking surface.
3. If needed, change the speed by pressing
the desired button.
To turn off the appliance press the first speed
button
again.
5.2 Hob²Hood function
It is an automatic function which connects the
hob with a hood. Both the hob and the hood
have an infrared signal communicator. Speed
of the fan is defined automatically on basis of
mode setting and temperature of the hottest
cookware on the hob. You can also operate
the fan using the hob manually. The function
can be activated from panel of the hob.
For more information how to use the
function refer to the hob user manual.
5.3 Filter notification
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter. The
filter indicator is turned on for 30 seconds
if the grease filter must be cleaned. The filter
indicator flashes for 30 seconds if the
charcoal filter must be replaced or cleaned.
Refer to cleaning the grease filter in care
and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To reset the function press the button for
3 seconds.
To activate or deactivate function:
1. To activate function press the button
for 3 seconds.
If the function is activated, the indicator
flashes two times.
2. To deactivate function press the button
for 3 seconds.
If the function is deactivated, the indicator
flashes ones.
5.4 Remote-control
The appliance can be controlled with a
remote-control. Visit local supplier to buy the
remote-control.
The connection is originally enabled.
To connect or disconnect remote-control:
1. Switch off the appliance.
2. Press the
for 3 seconds.
The indicator on control panel flashes twice if
function is enabled and once if disabled.
63
To Next Page
Loading...
