AEG DPB5650M - Page 5

5
ENGLISH
5. CONTROLS
The hood is tted with a control panel with
aspiration speed selection control
and a light switch to control cooking area
lights. Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes
prior to cooking and to leave in operation
during cooking and for another 15
minutes approximately after terminating
cooking.
L3
OFF!
ON!
L1
L2
L
4
1
2
5
4
3
-
+
1 Button ON/OFF light
2 Button ON/OFF Timer: delayed switch-off
of the selected suction speed (power):
Suction speed (power) 1: 20 minutes
Suction speed (power) 2: 15 minutes
Suction speed (power) 3: 10 minutes
Intensive suction speed (power): 5
minutes
3 Button OFF / Decrease of suction speed
(power)
4 Button ON / Increase of suction speed
(power)
5 Display, showing:
a. Suction speed (power): LEDs L1 –
L2 – L3 - L4 (flashing) light up according
to the selected suction speed (power).
Note: the L4 LED – intensive suction
speed (power) works for about 5 minutes,
then the hood sets the intermediate
speed.
b. Timer: the LED of the selected
speed flashes to indicate that the timer is
active.
c. Grease filter saturation: the L3
and L4 LEDs flash alternately at short
intervals of time.
d. Activated charcoal filter saturation:
the L3 and L4 LEDs flash simultaneously
at short intervals of time.
Reset of the lter saturation indicator: perform
lter maintenance, then press button 2 until
the LEDs turn off.
Note: The activated charcoal lter saturation
is normally disabled and is enabled only if
the hood is used in the ltering version (with
charcoal lter installed).
In order to activate it, proceed as follows:
- Switch off the hood
- Keep pressed simultaneously buttons
3 and 4, until the LEDs L1 and L2 ash
briey.
Repeat the operation to disable; only LED L1
ashes briey.
6. LIGHTING
X66164MP1 - X69164MP2 - DPB5650M/A
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the LED
light.
To replace lights, contact authorised spare
part center.