AEG DPE5650G - LED Lighting System

www.aeg.com
6
saturation signal: normally, this function is
disabled; to activate it, switch off the hood
(OFF) and simultaneously press buttons T3
and T5 for more than 3 seconds. LEDs L3
and L5 will start flashing.
To disable repeat the operation: LEDs L3
and L5 light up with steady light.
Resetting the filters’ saturation
indicator:
With the hood on (ON) press button T2 for
more than 2 seconds; all LEDs will light up
briefly.
Note: if necessary, repeat the operation
in case both indicators (grease filter and
activated charcoal filter) are active.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the
LED light.
For replacement, contact the technical
service.
Downloaded from www.vandenborre.be