Step 3 Pull the rear end of the shelf
support away from the side
wall and remove it.
Step 4 Install the shelf supports in
the opposite sequence.
12.3 How to use: Pyrolysis
Clean the oven with Pyrolysis.
WARNING!
There is a risk of burns.
CAUTION!
If a hob is installed above
the oven or if there are other
appliances installed in the
same cabinet, do not use
them at the same time as
this function. It can cause
damage to the oven.
Before the Pyrolysis:
Turn off the oven and
wait until it is cold.
Remove all accessories. Clean the oven floor and the in‐
ner door glass with warm water,
a soft cloth and a mild deter‐
gent.
Step 1
Set the function: . - flashes.
Step 2
, - press to set the cleaning mode.
Option Cleaning mode Duration
P1 Light cleaning 1 h
P2 Normal cleaning 1 h 30 min
Step 3
- press to start the cleaning.
Step 4 After cleaning, turn the knob for the heating functions to the off position.
During the cleaning the oven lamp is off. The oven door stays locked. When the oven
is cold, the door unlocks.
When the oven is at the set temperature, the door locks. Until the door unlocks the display
shows: the bars of the heat indicator, . To stop cleaning before it is completed, turn the
knob for the oven functions to the off position.
When the cleaning ends:
Turn off the oven and
wait until it is cold.
Clean the cavity with a soft
cloth.
Remove the residue from the
bottom of the cavity.
ENGLISH 23
To Next Page
