Programme
1)
2)
Water
(l)
Energy
(kWh)
Duration
(min)
P5 10 0.9 30
P7 12 - 14 0.8 - 1.0 82 - 92
P8 12 - 13 1.1 - 1.3 230 - 250
P9 4 0.1 14
P0 10 0.86 60 - 70
1)
The pressure and the temperature of the water, the variations of the mains supply, the options, the
quantity of dishes and the degree of soil can change the values.
2)
The values for programmes other than ECO are indicative only.
3)
In accordance with the 1016/2010 regulation.
4)
In accordance with the 2019/2022 regulation.
5.2 Information for test
institutes
To receive the necessary information for
conducting performance tests (e.g.
according to EN60436 ), send an email
to:
info.test@dishwasher-production.com
In your request, please include the
product number code (PNC) found on
the rating plate.
For any other questions regarding your
dishwasher, please refer to the service
book provided with your appliance.
6. SETTINGS
6.1 Programme selection
mode and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter user mode.
Settings available in the user mode:
• The level of water softener according
to the water hardness.
• Activation or deactivation of the rinse
aid empty notification.
• The level of rinse aid according to the
required dosage.
• Activation or deactivation of the
acoustic signal for the end of a
programme.
• Activation or deactivation of the
AirDry.
As the appliance stores the saved
settings, there is no need to configure
it before every cycle.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode
the following way:
www.aeg.com10
To Next Page
Loading...
Need help?
General
