There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously and until
the indicators
, , , ,
and flash and the display is
blank.
2. Press
• The indicators , , ,
and are off.
• The indicator still flashes.
• The display shows the current
setting: = Acoustic signal off.
3. Press to change the setting.
= Acoustic signal on.
4. Press on/off to confirm the setting.
6.6 How to set the colour of
the TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously and until
the indicators , , , ,
and flash and the display is
blank.
2. Press .
• The indicators
, , ,
and are off.
• The indicator
still flashes.
• The display shows a number and
letter C. Each number refers to a
different colour.
– = TimeBeam
deactivated.
3. Press
repeatedly to change the
colour.
4. Press on/off to confirm the setting.
6.7 AirDry
AirDry improves the drying results with
less energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
open. This can cause
damage to the appliance.
CAUTION!
In case of presence of
children, the AirDry system
can be deactivated if you
want to keep the door
closed in the end of the
cycle.
AirDry is automatically activated with all
programmes excluding
To improve the drying performance refer
to the XtraDry option or activate AirDry.
www.aeg.com
12
To Next Page
Loading...
