EasyManua.ls Logo

AEG FSK74747P - 9.1 Using the detergent; 9.2 How to select and start a programme using MY TIME selection bar; 9.3 How to activate ​EXTRAS; 9.4 How to start the AUTO Sense program

AEG FSK74747P
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9.1 Using the detergent
A
B
C
CAUTION!
Only use detergent specifically designed
for dishwashers.
1. Press the release button (A) to open the
lid (C).
2. Put the detergent (gel, powder or tablets)
in the compartment (B).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the lid locks
into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
The upper ends of the two vertical ribs
inside the compartment (B) indicate the
maximum level for filling the dispenser
with gel (max. 30ml).
9.2 How to select and start a
programme using MY TIME
selection bar
1. Slide your finger across MY TIME
selection bar to choose a suitable
programme.
The light related to the selected
programme is on.
The ECOMETER indicates the level of
energy and water consumption.
The display shows the programme
duration.
2. Activate applicable EXTRAS if desired.
3. Close the appliance door to start the
programme.
9.3 How to activate EXTRAS
1. Select a programme using MY TIME
selection bar.
2. Press the button dedicated to the option
you want to activate.
The light related to the button is on.
The display shows the updated
programme duration.
ECOMETER indicates the updated
level of energy and water
consumption.
By default, options must be activated
every time before you start a programme.
It is not possible to activate or deactivate
options while a programme is running.
Not all options are compatible with each
other.
Activating options often increases the
water and energy consumption as well as
the programme duration.
9.4 How to start the AUTO Sense
program
1. Press .
The light related to the button is on.
The display shows the longest
possible program duration.
2. Close the appliance door to start the
program.
The appliance senses the type of load and
adjusts a suitable wash cycle. During the
16 ENGLISH

Table of Contents

Related product manuals