AEG K 19 E - Troubleshooting; Air-Conditioner Does Not Function; Brief Operation Due to Safety Tripping; Appliance Blows Fuses

Troubleshooting
PROBLEM CAUSE REMEDY
‘The air-
conditioner does
not function
The air-conditioner
functions for a
brief period only,
because the safety
circuit-breaker has
been tripped. The
® pilot lamp
flashes
The appliance
constantly blows
the fuses
if the © pilot lamp is not lit
- power failure
- the appliance is not plugged in
if the Memo Control pilot lamp is flashing
- less than 3 minutes have passed since
the appliance was last switched off
if the Conditioning lamp is flashing
- inconditioning mode: the temperature
in the room is lower than the selected
temperature
if the Heating lamp is flashing
- inheating mode: the temperature in the
room is higher than the selected tempe- -
rature
ifthe B@ FULL pilot lamp is lit
- the condensation canister is full
- ‘the condensation canister is not fitted
properly
the exhaust hose is obstructed
the exhaust hose is kinked
the safety float has switched the appliance
off
the condenser fan has jammed
the control circuit board is faulty
The air-
conditioner
functions but the
room is not
cooled:
The air-
conditioner does
not heat the room
TECHNICAL ASSISTANCE
® window open
source of heat in the room. (heater, lamp
etc.) or the room is very crowded
the air exhaust hose has become detached
the thermostat is set too high
the air filter is dirty
the air-conditioner is not powerful enough
for the size or the conditions of the room
the safety thermostat which protects the
heating element has intervened
e waituntil the power supply is restored
e insert the plug
wait three minutes
turn the thermostat knob slowly to
the maximum cooling position.
e turn the thermostat knob slowly to
the maximum heating position
empty the canister and restart the
appliance
fit the canister
remove any obstruction from the air
exhaust hose.
¢ position the hose correctly. Press the
on/off switch twice
e drain the condensation from the tray
through the drainage tube. If this fault
persists, contact your nearest Service
Centre |
e contact your nearest Service Centre
e contact your nearest Service Centre
switch the appliance off and contact
your nearest Service Centre
close the window
remove source of heat
re-attach the air exhaust hose
e lower the thermostat setting
clean the filter
to restart the appliance, remove the
plug from the socket for afew minutes.
Eliminate the’ cause of overheating
and then re-insert the plug.
Most malfunctions are caused by a very minor and easily solved problem. Before contacting your nearest authorised
Service Centre for assistance, consult the troubleshooting chart below.
Do not carry out any repair operations other than those listed, especially on the electrical equipment in the unit. If the
Service Centre is called out to perform any of the operations listed, the cost. will be charged to you, even during the
guarantee period.
2/