Setting up and connection instructions
45
Setting Up the Unit
3
Washing machines with curved panels are not suitable for substruc-
tures.
Transporting the Unit
• Do not place the washing machine on its front side or on its right side
(looking from the front). Otherwise the electrical components can get
wet.
• Never transport the unit without using the transport safeguard. Do
not remove the transport safeguard until you reach the installation
site. Transporting the unit without the transport safeguard can result
in damage to the unit.
• Never lift the unit by the open filling door or by its base.
When transporting the unit with a sack trolley:
• Attach the sack trolley only at the side. The scoop of the sack trolley
must not be longer than 24cm, otherwise the float switch can be
destroyed.
Remove the Transport Safeguard
Attention! It is essential to
remove the transport safeguard
before putting the unit into oper-
ation! Keep all parts of the trans-
port safeguard in a safe place for
possible later transport (moving
house).
0 1. Open both hose holders on the
rear of the unit and remove the
hoses and the mains cable.
To Next Page
Loading...
Need help?
General