When you set a programme with prewash, put the detergent for
prewashing phase directly into the drum.
Always follow the instructions that you find on the packaging of the
detergent products, but we recommend that you do not exceed the
maximum indicated level ( ). This quantity will however guarantee the
best washing results.
After a washing cycle, if necessary, remove any detergent residue from
the detergent dispenser.
10.3 Select the required
programme by means of the
programme selector dial
Turn the programme selector dial to the
required programme. The selector can
be turned either clockwise or
anticlockwise. The green light of button
Start/Pause
starts to flash. The pilot
lights corresponding to all phases
composing the selected programme are
on.
On position
the programme is reset
and the machine is switched OFF.
At the end of the programme the selector
dial must be turned to position to
switch the machine off.
If you turn the programme
selector dial to another
programme when the
machine is working, the
lights in the programme
progress display will start to
flash to indicate a wrong
selection. The machine will
not perform the new
selected programme.
10.4 Select the spin speed,
rinse hold or no spin option
Select the spin speed, Rinse Hold option
or No Spin option by turning the spin
speed selector.
• The position 1300 is equivalent to 900
rpm for the Synthetic and Wool
programmes and 700 rpm for the
Delicate wash programme.
Rinse hold Spülstopp
By selecting this option the water of the
last rinse is not emptied out to prevent
the fabrics from creasing. When the
programme has finished, the light ENDE
is lit to indicate that the water must be
emptied out (See: 'At the end of the
programme').
No spin 0
By selecting this option all the spinning
phases are excluded. To be used for
extremely delicate material. The machine
will add some additional rinses to the
cotton and synthetic programmes.
For the maximum spin speed allowed by
each programme, refer to the chapter
'Programme Chart'.
10.5 Select the desired
options
Depending on the programme, different
functions can be combined. These must
be selected after choosing the desired
programme and before pressing the
button Start/Pause . The relevant light
will illuminate.
V
o
r-
wäs
che
Extra -
Kurz
K
u
rz
Z
e
it
Sparen
Leich
t
-
bügel
n
If an incorrect option is selected, the
corresponding indicator lamp flashes for
about 2 seconds. For the compatibility of
the options with the washing
programmes, refer to the chapter
'Programme Chart'.
ENGLISH 17
To Next Page
Loading...
