10.6 Select the Delay Start
Before you start the programme, if you
wish to delay the start, press the button
Zeitvorwahl repeatedly, to select the
desired delay. The light corresponding to
the set delay lights up.
You must select this option after you
have set the programme and before you
press button Start/Pause.
You can cancel or modify the delay time
at any moment, before you press button
Start/Pause.
Cancelling the delayed start after having
pressed button Start/Pause:
1. Set the washing machine to PAUSE
by pressing button Start/Pause.
2. Press the button Zeitvorwahl once,
the light relevant to the selected
delay goes off.
3. Press button Start/Pause again to
start the programme.
The selected delay can be
changed only after selecting
the washing programme
again.
The door will be locked
throughout the delay time
(door locked light lit).
The Delay Start can not be
selected with Abpumpen or
Schleudern programme.
10.7 Starting the programme
To start the selected programme, press
the button Start/Pause; the
corresponding pilot light stops flashing
and remains on.
The indicator of a current washing phase
illuminates and the door is locked.
10.8 Altering an option or a
running programme
It is possible to change any option before
the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing
the button Start/Pause.
The programme can be changed as long
as the button Start/Pause has not been
pressed. Changing a running programme
is possible only by resetting it. Turn the
programme selector dial to and then
to the new programme position. Start the
new programme by pressing the button
Start/Pause again.
10.9 Interrupting a
programme
Press the button Start/Pause to interrupt
a programme which is running, the
corresponding light starts to flash. Press
the button again to restart the
programme.
10.10 Cancelling a
programme
Turn the selector dial to position to
cancel a programme which is running.
Now you can select a new programme.
10.11 Opening the door after
the programme has started
First set the machine to pause by
pressing the button Start/Pause.
After some minutes, the door can be
opened, when the following conditions
are observed:
• The water temperature is below 55°C.
• The water level is below the bottom
edge of the door.
• The machine doesn’t spin.
If you cannot open the door but it is
absolutely necessary to open it you have
to switch the machine off by turning the
selector dial to
. After few minutes the
door can be opened (pay attention to
the water level and temperature!).
After this procedure, it will be necessary
to set the programme and the options
again and then press the button Start/
Pause.
www.aeg.com18
To Next Page
Loading...
