We recommend that
you keep the
packaging and the
transit bolts for any
transport of the
appliance.
5. Put the plastic caps, that you find in
the user manual bag, in the holes.
5.3 Information for
installation
Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard
floor. The appliance must be levelled and
stable. Make sure that the appliance
does not touch the wall or other units and
there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
The inlet hose
Before connecting up the machine to
new pipework or to pipework that has not
been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected in the
pipes.
To protect drinking water enclosed
non-return valve must be installed
between the water tap and the water
supply hose. This valve must not be
assembled on appliance. Set the hose
correctly. Make sure to tighten the ring
nut to prevent leaks.
1. Connect the water inlet hose to the
back of the appliance.
2. Position it toward left or right
depending on the position of the water
tap. Make sure that the inlet hose is not
in vertical position.
3. If necessary, loosen the ring nut to set
it in the correct position.
4. Connect the water inlet hose to the
cold water tap with 3/4'' thread.
ENGLISH 9
To Next Page
Loading...
