Operating Hours
Counter
It is possible to visualise the total operating time of the appliance
in hours, starting from the first switching on. This value will count
operating time of the cycles (does not include pauses, delayed
start time). To visualise this value, proceed as follows:
1. Switch the appliance on by pressing On/Off button.
2. Turn the programme knob to the MyWash 49min programme
(1st position clockwise).
3. Press and hold the Extra Aclarado/Enxag. and Extra Rápido
buttons for some seconds (within 10 seconds after the switch‐
ing on. After these 10 seconds, the key combination activates
and deactivates the acoustic signals).
4. After 3 seconds the total hours operated by the appliance are
shown in the display: e.g. 1276 hours, the display shows the
text Hr for 2 seconds, 12 (thousands and hundreds) for 2 sec‐
onds and 76 (tens and units).
If the procedure does not work (due to timeout,
wrong programme dial position or wrong keys
combination), switch the appliance off and repeat
sequence from the beginning.
Factory Reset
This function allows to restore the factory default options. To acti‐
vate this option follow steps below:
1. Switch the appliance on by pressing On/Off button.
2. Turn the programme knob to the Eco 40-60 programme (3rd
position clockwise).
3. Press and hold the Extra Aclarado/Enxag. and Extra Rápido
buttons for some seconds (within 10 seconds after the switch‐
ing on. After these 10 seconds, the key combination activates
and deactivates the acoustic signals).
4. The display will show for about 5 seconds.
If the procedure does not work (due to timeout,
wrong programme dial position or wrong keys
combination), switch the appliance off and repeat
sequence from the beginning.
9.2 Display
ENGLISH 25
To Next Page
Loading...
