1. Touch the Remote Start button
and the indicator blinks on the
display for a few seconds.
Rivedere immagine
2. Touch the Inicio/Pausa button to
activate the Remote Start before the
indicator stops blinking.
The indicators
and appear on the
programme summary screen and the
door is locked. Now it is possible to start
the programme remotely.
When touching the Inicio/
Pausa button after the
indicator stops
blinking, the Remote Start is
not activated, but the set
programme starts.
To remove the Remote Start, tap on the
Remote Start button and confirm by
pressing the Inicio/Pausa button.
11.4 Over-the-air update
The App may propose an update for your
appliance.
The update is accepted via App only.
If a programme is running, the App
notifies that the update will start at the
end of the programme.
During the update, the appliance shows
in the display.
Do not switch off or unplug the appliance
during update.
The appliance will usable again at the
end of the update, without any
notification about successful update.
If an error occurs, the appliance shows
in the display: just press any
buttons or turn the knob to return to
normal use.
12. DAILY USE
WARNING!
Refer to Safety chapters.
12.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press the On/Off button for a few
seconds to activate the appliance.
A short tune sounds (if activated). The
appliance automatically proposes a
default programme. The relevant
indicator illuminates.
The display shows the maximum load,
the default temperature, the default spin
speed, the indicators of the phases
making up the programme and the cycle
duration.
12.2 Loading the laundry
1. Open the appliance door.
2. Shake the items before you put them
in the appliance.
3. Put the laundry in the drum, one item
at a time.
Make sure not to put too much laundry in
the drum.
4. Close the door firmly.
www.aeg.com34
To Next Page
Loading...
