AEG L9FEB946 - Page 33

Your email and password. If you do
not have an account, create a new
one following the instructions in "My
AEG" .
5. Follow the instructions on the App for
the appliance registration and
configuration.
11.2 Configuring the
appliance wireless
connection
1. Press the On/Off button for a few
seconds to activate the appliance.
Wait about 10 seconds before
proceeding with wireless
configuration.
2. Select a programme by turning the
programme dial.
3. Press and hold the Temp. °C and the
Centrif. buttons simultaneously for a
few seconds until a 'click' sounds.
Release the buttons. appears on
the display for 5 seconds and the
indicator starts blinking.
The wireless module begins starting up.
Make sure that you APP is
ready for connection.
4. After about 45 seconds,
(Access Point) appears on the
display.
The access point will be open for about 3
minutes.
5. Configure the "My AEG" app on your
smart device and follow the
instructions to connect the appliance
to your Wi-Fi network.
6. If the connectivity is configured, when
the programme information screen
returns, the indicator is on the
display.
Every time you switch the
appliance on, the appliance
takes 45 seconds to connect
to the network automatically.
When the indicator stops
blinking the connection is
ready.
To switch the wireless connection off,
press and hold the Temp. °C and the
Centrif. buttons simultaneously for a few
seconds until the first acoustic signal:
appears on the display for 5
seconds.
If you switch the appliance
off and on again, the
wireless connection is
automatically off.
To remove the wireless credentials,
press and hold the Temp. °C and the
Centrif. buttons simultaneously for 10
seconds until the second acoustic signal:
appears on the display.
11.3 Remote Start
The Remote Start enables you to start a
cycle in remote control.
The Remote Control
activates automatically when
you press the Inicio/Pausa
button to start the
programme, but it is also
possible to start a washing
programme remotely.
When the App is installed and the
wireless connection is complete, you can
activate the Remote Start:
ENGLISH 33