Why AEG Washer is not working?
If your AEG washing machine isn't working, make sure the mains plug is correctly inserted. Also, check the fuse and replace or reset it if needed. Ensure the door is fully closed until the lock engages audibly.
What to do if AEG LAVAMAT W 1020 Washer doesn't spin and there is water in the drum?
If your AEG washer doesn't spin and there's still water in the drum, check if the (RINSE HOLD) function is selected and deselect it.
Why AEG LAVAMAT W 1020 is not taking in water?
If your AEG washer isn't taking in water, first ensure that the water tap is fully open. If the tap is open, check the sieve in the threaded fitting on the water inlet hose. If it's blocked, unscrew the hose from the tap, remove the sieve, and clean it under running water.
What to do if it is not possible to open the door of AEG LAVAMAT W 1020 Washer?
If you cannot open the door of your AEG washer, it may be locked for safety reasons. Wait 1-2 minutes after the program has ended before attempting to open it.
What to do if water cannot be completely pumped out of AEG LAVAMAT W 1020 Washer because the drain hose is kinked?
Check the drain hose for any kinks and remove them. If necessary, clean the circulation pump.
What to do if AEG Washing is not spun properly, and water is still visible in the drum?
If your AEG washing isn't spinning properly and water remains in the drum, check the drain hose for any kinks and remove them. If you have a siphon connection, ensure the siphon is not blocked and clean it if necessary. Also, switch off the machine and unplug from the mains, then clean the circulation pump. For maximum pumping heights exceeded, please contact customer service who have a retrofit kit for pumping to heights of greater than 1m.
Why AEG Washing machine vibrates during operation or is unstable?
If your AEG washing machine vibrates excessively or is unstable during operation, the height adjustable threaded feet may not be correctly adjusted. Adjust the feet according to the installation and connection instructions.
What to do if water runs out from under the AEG Washer?
If you notice water leaking from your AEG washing machine, several issues could be the cause. First, check if the threaded fitting on the water inlet hose is leaking and tighten it. Also, inspect the drain hose for leaks and replace it if necessary. Ensure the circulation pump cover is properly closed. Finally, if washing is trapped in the door, stop the program, remove the washing, and start a new program.
Why there is excessive foaming during the main wash in AEG Washer?
Excessive foaming during the main wash cycle of your AEG washer is likely due to using too much detergent. Ensure you dose the detergent exactly according to the manufacturer’s instructions.
What to do if softener is not washed in AEG LAVAMAT W 1020 Washer, and compartment for conditioner is full with water?
If the softener isn't being dispensed in your AEG washer and the conditioner compartment is full of water, the suction cap in the compartment may not be correctly positioned or is blocked. Clean the detergent drawer and firmly reposition the suction cap.
Covers general safety standards, intended use, and prior to initial start-up procedures.
Provides specific safety guidelines regarding children and the washing machine.
Outlines general safety precautions for operating, cleaning, and maintaining the appliance.
Provides an overview and explanation of the washing machine's control panel.
Guidance on sorting and preparing laundry items before washing.
Advice on selecting and using appropriate detergents and conditioners.
Step-by-step guide on how to operate the washing machine through a cycle.
How to select the program, temperature, and additional options for a wash cycle.
A guide to identifying and resolving common malfunctions with the washing machine.
Instructions for manually draining water from the machine in case of malfunction.
Steps for accessing and cleaning the appliance's circulation pump.
Essential safety measures to follow during the installation process.
General guidance on the proper placement and installation of the washing machine.
Detailed steps for removing all shipping braces and protective elements.
Specifies the required and maximum permissible water pressure for the appliance.
Instructions for connecting the water inlet hose to the appliance and water tap.
Guidance on connecting the drain hose to a siphon, basin, or bathtub.
To Next Page
General